Product Description
HARD Motorsport - BMW E36 Dash End Cap Kit
Inspired by BMW Motorsport parts in our factory built touring cars, Our HARD Motorsport dash end caps are intended to be used to clean up and finish the dash ends after a roll cage has been installed. Hacking up the dash and getting it fitted around the A-pillar bar can be time consuming. These allow for a more clean and finished look while making install a lot easier and saves a lot of time. Just cut off the ends of the stock dash, then trim out our plastic ends to fit around the bar. The ABS thermoformed plastic is easy to modify and easy to install. No more need to install and remove a full dash just to get it fitted in your car.
FEATURES:
- Thermoformed ABS plastic with textured finish for a more factory appearance and less glare.
- Easy to modify.
- Covers factory window defrost vents.
- A perfect complimentary peice to our other dash and gauge panel components.
Fitment:
- Fits factory E36 Sedan dash. (not tested for early non-airbag dash)
Note: Not suitable for E36 318ti Compact
Slight variances in material and the thermoforming process are possible. We provide a semi-rough cut panel that may require additional trimming and modification to get the fitment and clearance that you desire.
A UV protective coating, paint, or vinyl wrap should be installed to help reduce reactiveness to UV radiation.
We use ABS Plastics because it is ideal for the thermoforming process, is widely available, easy to modify and customize, and can be worked and painted with standard finishes such as automotive paints and vinyl wraps. Plastics are also less expensive than heavier alternatives, such as fiberglass.ABS Plastic is reactive to UV radiation and temperature. Expansion warping may occur with extended exposure to both direct and indirect sunlight, even in overcast conditions. Please keep in mind that a car’s interior will reach temps much higher than the atmospheric temp in minutes when left in the sun without ventilation. Deformation due to UV or heat exposure will not be considered a manufacturing defect.
